7. Installing the Motherboard and VGA CablesOnce the motherboard is installed in the casing next step is to install the cable I / O on the motherboard and the casing panels.
1. Connect the data cable for the floppy drive connector on the floppy controller on the motherboard
2. Attach the IDE cable to the primary and secondary IDE connector on the motherboard.
3. For non-ATX motherboard. Connect the serial and parallel port cable to the connector on the motherboard. Note the position of pin 1 to install.
4. On the back of the casing there is a hole to install additional types of non-slot port. Open the lock plate screw holes covered lalumasukkan port connector port that you want to install and plug the screw again.
5. When the mouse port is not available at the back of the card casing mouse connector should be installed and connected to the mouse connector on the motherboard.
6. Wiring connectors on the front panel of the switch casing, LED, internal speakers and ports mounted in front of the casing when the motherboard. Check your motherboard diagram to locate the proper connector.
Connector
0 komentar:
Posting Komentar