installing the Drive

22.48 komputer No Comments

8. installing the Drive
The procedure to install the hard disk drive, floppy, CD ROM, CD-RW or DVD is the same as follows:
1. Remove the drive bay cover pellets (space to drive on the casing)
2. Enter from the front drive bays with the first set the jumper settings (as master or slave) on the drive.
3. Adjust the position of the screw holes on the drive and the casing and replace the retaining screw drive.
4. Connect the IDE cable connector to the drive and the connector on the motherboard (the primary connector is used first)
5. Repeat steps 1 samapai 4 for each installation of the drive.
6. If the IDE cable connected to the du drives make sure the jumper setting of both the difference in the first drive set as master and the other as slave.
7. Secondary IDE connector on the
motherboard can be used to connect two additional drives.
8. The floppy drive is connected to a special connector on the motherboard floppy
9. Connect the power cable from the power supply to each drive.
Each drive